Continuous Milk Rinse

1. Locate the access panel

On the right-hand side of the machine, remove/open the small cover as shown in Picture 1.

2. Check the hose in the pinch valve

Inside the opening you should see the small metal roller and the clear milk hose.

The hose should sit firmly in the pinch mechanism, as shown in Picture 2.

This position allows the valve to clamp the hose during self-clean so only steam is drawn through.

3. Correct any misalignment

If the hose looks like Picture 3 (sitting forward/loose and not properly in the pinch valve), gently feed it back into the pinch mechanism so it matches Picture 2.

Make sure the hose is straight and fully seated in the pinch area.

4. Close the panel and test

Run a milk drink and allow the machine to perform its next self-clean cycle.

The machine should now only draw steam during self-clean, reducing milk usage and preventing the tray from constantly filling.